BM5.5 manual

(Motorcycle Streaming Media Device)

Specification	Description
Main chip (processor)	SSC8836Q Dual-Core A53
Screen	5.5 inches
Screen Pixels	1440x720
DDR memory (RAM)	Built-in 2GB DDR3
Flash memory	1GB NAND flash
Camera	Sony IMX307, AHD 1080P (front and rear)
Camera field angle	140° wide angle
Screen brightness	1000 nits, automatic brightness adjustment
Temperature range	Operates from -20°C to 70°C (-4°F to 158°F)
Water/Dust Resistance	IP67 certified
Storage Support	TF card up to 128GB
Wireless Features	Wireless CarPlay and Android Auto
Bluetooth	Support
Recording Features	G-sensor, Emergency recording, Loop recording
Anti-shake	Intelligent Anti-Shake Technology
Auto-connection	Automatically connects to the bike, recording starts automatically
Plug-and-Play	No complicated wiring required, safe and easy setup

Preface

Dear User:

Thank you for choosing this product. In order to have a good using experience, please read this manual carefully.

Before using this device, please carefully read and understand the following:

To avoid accidents, please do not use or view this device while driving.
Please do not install or repair this device yourself.
Unprofessional behavior may cause danger or damage the motorcycle's electrical system.

Please ensure the device is installed by a professional electronic technician:

For proper installation, please use standard components and install with the specified method.
Before installing this device, a temporary trial installation test is required. Please contact the seller if any abnormality occurs.
After completing the installation, please confirm whether other devices in the vehicle are connected correctly.
Please do not randomly power on the vehicle wiring to avoid damaging the computer and important components.
To avoid short circuiting the vehicle system, we recommend removing the negative terminal wire of the battery before installation. Do not start the vehicle and then install in power on mode.

This product is suitable for BMW motorcycle mount.
Align the machine with the bracket, paying attention to the direction shown in the diagram.
Press the machine into the bracket.
After the machine is installed, the vehicle can be started and used.
After the machine is installed, pressing the left button can lock the machine.
The button can be removed by pressing the right button.

Click on the CarPlay icon on the main interface.
Open your iPhone's Bluetooth settings and find the corresponding model of the machine to connect to.
Connect Bluetooth and click pairing, make sure the phone's WiFi is on.
After the connection is successful, the machine displays the CarPlay interface, which indicates that the connection was successful.
Click Home to launch CarPlay and return to the main interface of the machine.

Knob Control Title

Knob Controls

Make sure the CarPlay or Android Auto connection is successful.
Long press “MENU个” (figure 1) for 2 seconds to wake up the knob control function (it will exit automatically if there is no operation for 15 seconds).
Press “MENU 1” (figure 1) briefly to switch modes.
In the recorder preview interface, briefly press the knob left button (figure 5) to preview the front and rear, and briefly press the knob right button (figure 6) to take a photo.
When a call comes in, briefly press the Knob Right button (figure 6) to answer, briefly press the Knob Left button (figure 5) to cancel.
In the CarPlay or Android Auto interface, short press the knob left (figure 5) , right (figure 6) , up (figure 3) and down (figure 4) to move the cursor to select a menu. Long press the knob right (figure 6) for 1 second to "confirm", long press the knob left (figure 5) for 1 second to go back to the previous.

1. Find the ABS sensor in the picture, located under the second seat.
2. Unplug the ABS sensor harness and connect it to the adapter wire.
3. Connect the CAN box to the harness on the adapter line and secure it in place.